Lower Motor Mounts

Using the first part to help me visualize the mirror image. This table I built is pretty handy - I can clamp the angle down while I cut it. I wish I had built it much earlier.

Rough cut - clamping the part together to mark the cut lines.

Lined up for cutting.

The cut line transfered to the mirrored part. The traced lines are a bit "softer" than the ones traced from the card templates.

Rough cut - bandsaw again.

This is how I held the piece down while filing. I put clamping rails on either side of the table.

A closeup of the line I'm filing to.

< Last Home Next >